New product of TSR!
Through continuous attention to customer needs and long-term research and development investment, our new product have recently been put on the market after successful trial
Through continuous attention to customer needs and long-term research and development investment, our new product have recently been put on the market after successful trial
(1)After using centrifugal casting process,the strength of the rolls was elevated largely,and the technical difficult problem of roll breaking off has been basically solved. (2)The
wear characteristic of rolls used for section mills is unique: the wear value of the bottom of the pass is greater than that of the
Performance of rolls depends on the microstructure. By adjusting the chemical composition, solidification conditions and heat treatment process to meet the requirements of performance. Obtaining
1) Selected the materials for rolls which have good wear resistance and thermal crack resistance. The hardness of rolls should be controlled within a reasonable
According to the matching diagram of rolls, manufacture a specific roll mold with grooves in advance, then the roll casted by the mold is called grooved roll.
Grinding wheels for grinding cold rolls are generally selected with soft grinding wheels. Particle size of the grinding wheels should be between 80 mesh and
1 The selected grinding wheel is too hard; 2 When the grinding roller is used, the transverse feeding amount is too large, and the longitudinal
TSR ROLLS participated in the internationally famous METEC exhibition in Jun. Dozens of internationally renowned steel companies visited our booth this time. As the leading
Trust Stemming from Reliability